01-14-2005 10:57 AM - edited 03-13-2019 07:39 AM
I am implementing a "Cisco Office in a Box" solution at a customer's site. I am trying to bring up the T1 to their provider.
I have a 2651XM router with IOS 12.3.11T2. The "Cisco Office in a Box" solution came with a VWIC2MFT-T1-DI.
I cannot get the T1 to come up. I am connected to a Adit 600. The circuit is E&M wink-start. I was told that the command I need is:
router(config-controller)ds0-group 1 timeslots 1-10 type e&m-wink
The ds0-group command is not available to me with the current hardware/software configuration.
01-14-2005 11:27 AM
Do you have DSPs in the router??
01-15-2005 01:50 PM
Do you have an NM-HDV module?
Is the VWIC-2MFT-T1-DI in a larger module (NM-HDV)?
Also, this module requires DSPs. Or do you have onboard AIM DSPs?? If you have onboard AIM DSP's you don't require the NM-HDV module.
If you don't have either, you won't be able to bring up the voice component of the T1 interface.
hope this helps.
Paul
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide