Configuration of VIC2-2BRI-NT/TE

[vmgng3077]

Can you help me how to configure my ISDN card.

I have version 3.2 of CME and a 2801 router.

Internally call are working OK.

Victor

[anup.anand]

Check out this link for setting up ISDN

http://www.cisco.com/en/US/tech/tk652/tk653/technologies_configuration_example09186a008010ef6c.shtml

Once you have ISDN working, you need to setup dial-peers for incoming and outgoing calls. Check this link for dial-peers

http://www.cisco.com/en/US/tech/tk652/tk90/technologies_tech_note09186a008010fed1.shtml

Regards,

Anup

[vmgng3077]

Thanks. I used your link but it is not working.

There is someting strange. some times the light near the cable is on, sometimes it is off. What is the correct situation?

I am sendig the attachment of my running configuration.

[anup.anand]

The light going off and on sounds like a cabling issue or a bad card. Check the cables and also check with your ISDN service provider to verify connectivity.

Is the switch type supposed to be basic-net3? Please verify with your service provider.

When you do a "show isdn status", what is the Layer 1 and Layer 2 status?

Regards,

Anup

[Patrick Laidlaw]

Hello,

You should see multiple frame established if your talking to the isdn provider when you issue the "show isdn status" command.

Patrick

[vmgng3077]

The is the message with sh isdn status:

RGrafer#sh isdn status

Global ISDN Switchtype = basic-net3

ISDN BRI0/0/0 interface

******* Network side configuration *******

dsl 0, interface ISDN Switchtype = basic-net3

Layer 1 Status:

DEACTIVATED

Layer 2 Status:

Layer 2 NOT Activated

Layer 3 Status:

0 Active Layer 3 Call(s)

Active dsl 0 CCBs = 0

The Free Channel Mask: 0x80000003

ISDN BRI0/0/1 interface

dsl 1, interface ISDN Switchtype = basic-net3

Layer 1 Status:

ACTIVE

Layer 2 Status:

Layer 2 NOT Activated

Layer 3 Status:

0 Active Layer 3 Call(s)

Active dsl 1 CCBs = 0

The Free Channel Mask: 0x80000003

Total Allocated ISDN CCBs = 0

RGrafer#

Note that I have only coneted one cable (Isdn line) to port 0/0/1.

Is the reply OK to you? Layer 2 is Not Activeted? Why?

I only can contact my service provider on Monday.

Regards,

Victor

:-)