Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
One of our customer is having some Wireless PC's that are doing brigding between the wired network and wireless network. This is causing a lot of issues, like the DHCP request getting leaked from the Wired VLAN to wireless VLAN, resulting in sporadic...
We have a 2600, with 12.2(15)ZJ configured as a SIP gateway. Also have a third party SIP Proxy server. The proxy server requires all clients and user agents to register to it. The Cisco 2600 is not sending any REGISTER messages. My question is: Are 2...
Hi,On a HSSI interface, we are seeing that the OUTPUT BUFFER SWAPPED OUT counter is incrementing at a very high rate (it was 48233551 when we checked last time). As per documents, this value means "Number of output buffer allocation failures". From ...
When configuring a Cat 6000 (Cat OS 6.3) to send messages to a syslog server, using the command " set logging server severity <level> " will send all messages of the specfied level to the server. The level values are from 0 to 7. So if you set the le...
When you say " Ericsson PABX with IP card ", does it support any VoIP protocols like H323 or SIP?If yes, then you can configure the PABX as a H323 gateway or SIP Trunk in Callmanager. Regards,Anup
In the ICT configuration, do you have MTP Required Checked? If yes, can you uncheck that and reset the ICT and see if that helps.Also how about the Enable Inbound Faststart check box? Regards,Anup
Check this script. It uses the "Get Digit String" to collect the digits. Set the Input Digits to match the extension length of your phones and the maximum retries to 0 (so that the script doesn't keep looping over and over).In the Successful Step, do...
