cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
169
Views
0
Helpful
4
Replies

Configuring CCM for Inbound Calls

Kwakachunga
Beginner
Beginner

i have a voice gateway which has been configured to set up calls frm PSTN to a CCM using H.323 signalling.How do i configure the CCM so that the phones recieve inbound calls

4 Replies 4

mparekh
Participant
Participant

You will have to setup VoIP dial-peers on the h323 gateway pointing to the IP address of CCM:

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_configuration_example09186a0080094852.shtml

The voice gateway has already been configured with voip dial peers pointing to the CCM

dsantoyo
Beginner
Beginner

Hi, you have to add the H.323 GW in the CCM for Devices options>Gateways and then select H.323 GW. To receive calls from the GW you have to put the options for CSS in the GW config (there is an option for incoming calls) allowing those calls to the IP phones.

Daniel.