Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
i hav a server on my dmz1,i want users on the internet to access it on https....i hav an access list and a translation as shown belowstatic (outside,dmz1) 170.x.y.z 192.168.80.3 netmask 255.255.255.255 0 0access-list 1 permit tcp host proxy_server an...
I have about 200 users on two CCM 5.0 servers,the directory service keeps on hanging and becomes inaccessible and the service comes back after some time,any ideas as to the cause and remedies ?
when i do a 'show isdn status' i get state as TE_1 ASSIGNED or AWAITING_ESTABLISHMENT ,when i do a show int s0/3/1.15 serial is up,line protocol down,what could be the problem?The telco guys say everything is ok on their end though i dont trust them....
i have an interface on one of my dmz interfaces with ip address 172.27.127.1/24 to a LAN with networks 172.27.127.0/24 and 172.27.124.0/24...how do i reach the 172.27.124 network through this interface through the PIX dmz int ,can it accept a seconda...
Confirm if int vlan 500 is up(sh int vlan 500),if not do a no shut on the interface,then plug ur machine on to interface GigabitEthernet1/0/1(a member of vlan 500) ,give it an ip like 10.0.101.2 /24 then give it a default gateway of 10.0.101.2/24.......
