cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
351
Views
0
Helpful
1
Replies

Connection to PSTN via FXO port

m-constantine
Level 1
Level 1

Hi,

I am trying to set up a gateway to connect to the PSTN via an FXO port on a 1760 router. So far dialling in and out works fine however when either party disconnects, the other end does not hang up. I understand that FXO's do not transport the signalling so you have to configure the voice-port to detect the disconnect signal. However reading this url http://www.cisco.com/warp/public/788/signalling/fxo_disconnect.html and trying to play with the parameters hasn't fixed this issue. Has anyone got a sample config for such a setup for calls to the UK PSTN.

Any suggestions greatly appreciated,

Regards

Mike

1 Reply 1

hwei
Cisco Employee
Cisco Employee

what type of FXO card are you using? general FXO or FXO-M1/FXO-M2?