How to turn off/on DMP via command

[stucki]

Hello,

I have a couple 4400 DMPs that need to be turned on and off remotely.  How can this be done via a remote command and what is the command?  These DMPs are not connected to a DMM.

Thanks,

Jason

[keithcroft]

Try this to "RESTART" your DMP.

https://admin:default@w.x.y.z:7777/set_param?mng.reboot=1

admin= username assigned to access DMP

default= your dmp password

a.b.c.d= the IP address of your DMP

Let me know if this works. I do not have a DMP to test this on right now.

-Keith

[stucki]

Thanks Keith.

I have used this command but I was wondering if it were possible to power down the DMP at say 10 PM and then start it back up at 8 AM. 

Or do the DMPs typically run all the time?

Thanks,

Jason

[jdedell12]

Jason,

In most of our deployments we leave the DMP on all the time but we schedule turning the monitors on and off.

John

[keithcroft]

Jason,

4400's DMP Power consumption:

• Peak: 30W; average: 15W

Also John is correct. Scheduling down time of the LCD's would be the better "green initiative" here :-)

Hopefully your displays have the RS232 option. If so and you need a quick start see:

https://supportforums.cisco.com/message/3066692#3066692

Best Regards,

Keith

If this answers your question, Please take time to mark this

discussion answered & rate the response.