08-15-2002 08:12 AM - edited 03-12-2019 08:22 PM
I have CallManager 3.2, Unity 3.1, and IAD2400's running 12.2-8T. The Unity will light the MWI on the IP phones we have, but we have no stutter dial-tone on the analogs coming off the IAS2400. I'm using MGCP 0.1 between the CM and IAD's. CCO mentions stutter dial tone on the IAD's using xGCP, but I haven't found the doc that tells me if I need to configure it some where or if it should just work.
Thanks
Mark
08-22-2002 01:43 PM
Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen
If anyone else in the forum has some advice, please reply to this thread.
Thank you for posting.
09-11-2002 10:02 AM
The IAD2400 will not support stutter dial tone. We had to move to VG248 to make this and other analog functions work. This is an issue with the IADs and not the CallManager or the Unity. That's the response that we got from TAC.
Thanks
Mark
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide