Inbound calls on Call Manager Express

[philg]

Hello, We are planning an installation of CME. I hope to have at T1 that will consolidate multiple inbound phone numbers and terminate it on the CME router. I would then like to have all inbound calls forwarded to a single reception phone who can answer and then transfer if needed. Is this possible, and can the reception use a 7940 2 button phone? Thanks very much in advance for any advice.

[gogasca]

Hi Phil,

Configuring the phone

*********************

http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122newft/122limit/122z/122zj15/itsv30/its30phn.htm#wp2243578

Call transfer

*****************

http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122newft/122limit/122z/122zj15/itsv30/its30xfr.htm#wp2158760

http://www.cisco.com/univercd/cc/td/doc/product/access/ip_ph/ip_ks/its30/itsug/itsv3_12.htm#wp1044822

Auto Attendant

**************

http://www.cisco.com/univercd/cc/td/doc/product/software/ios123/123newft/123t/123t_7/cme31sa/cme31atd.htm#wp2158760

[philg]

Thank you, I was relying on the e-mail update to inform me of a reply to my post. That didn't work quite right.

So it appears that everything I was hoping for in CME is there.

Just to make sure, even though the 7940 only has two buttons, all the inbound calls can be sent to it even if they originated from multiple outside numbers?