Other Collaboration Subjects

Dear All,I want to ask a question About the Parititon, CSS and Route Pattern.I want to create Partition : Block_CALL_IDDWhich includes a block pattern : 9.001!On the other hand, I create a parition :PSTN which includes a pattern : 9.!I add a CSS the ...

Hi,I would like to implement extension mobility so that user could have the same extension when is logged in or logged out. i want extension mobility to block calls to PSTN when user is logged out.My problem is that i defined two partions one for ext...

Does anyone know if it is now possible to configure a 7940 and 7914 pair together in any of the newer builds of CM, and if so, which versions?Heard a rumor that it may be supported now...

I have this gut feeling this will not be a supported design. But can we somehow configure the 7609 for H323? if so how? OR... use a WS-X6608 blade and slot it into the chassis and register it with CM as an MGCP gateway?I am currently using the 3845 I...

Hi,We have a IPCC setup with CCM 4.0(2a) Sr2a integrated with IPCC express 3.5(2).PSTN calls are routed through the WAN to the IPCC setup.All the remote PSTN gateways(Cisco routers with T1) are registered as MGCP on the CCM.Due to security reasons we...

I am sure this has probably been addressed, but after searching for 2 hours I have given up.I have a customer whose received calls directory is not populating. In fact, none of the phones connected to the call manager can display received calls. Th...

Folks, Would someone be kind enough to share their SRST configuration with the forum.Thanks

We recently removed a 6608 blade and installed a CMM in a 6509 switch. The idea was to move from CAT OS to IOS. In slot one we installed a WS-SVC-CMM-6T1 module for PRI trunking. We now have three gateways registered to our CCM Cluster using PRI t...

We have a CMM (WS-SVC-CMM) installed in a 6509 switch. On port 4 we installed a WS-SVC-CMM-ACT module to expand our conference bridge capabilities. When I go over to the CCM Administration page and select SERVICE>>>MEDIA RESOURCES>>>CONFERENCE BRID...

We have recently implemented a DR Site and would like to put our CCM Publisher at that site. This would require us to change the ip address of the Publisher. Anyone know of any problems I may face when changing this IP address.

Hello, We are planning an installation of CME. I hope to have at T1 that will consolidate multiple inbound phone numbers and terminate it on the CME router. I would then like to have all inbound calls forwarded to a single reception phone who can ...

Hi,I'm trying to create a PCM file from a wav file. I'm following this link:http://www.cisco.com/en/US/partner/products/hw/phones/ps379/products_administration_guide_chapter09186a00803b1435.html#wp1088184I was wondering if you know of any good progra...

Hi all,We have two CCM 4.0(1)servers running on MCS platform. We upgraded the publisher to CCM 4.1(2) using the web download but when we tried to upgrade the subscriber the subscriber simply broke down. We commenced a new installation of 4.0(1) on th...

I have following scenario,PBX A---- H323 Gateway (orig) ----------H323 (destination)---PBX BFrom PBX A I am dialing 41250 it hits the gateway (orig) . In gateway (Orig) the dial-peer configs for 41250, I put a translate outgoing called to make it loo...