09-13-2005 09:25 AM - edited 03-15-2019 03:41 AM
Hi all,
i've got a router with only on ethernet and 2 sub-if. i would like to use the NM-HDV DSP for conferencing in CCM.
Is it possible to bind sccp local to on of the sub-if?
I already tried but it seems not to register to CCM.
Have someone already done this?
thank you
09-13-2005 03:15 PM
Yes you should be able to register it to the sub interface. The MAC address used is the same. Also, since SCCP connections are initiated by the end point (in this case, the router), you should be fine.
Check configs. Post them.
Then, do a
conf t
no sccp.
do debug sccp packet
sccp
Then, send the debugs to us. Thanks!
09-14-2005 05:37 AM
i apologies, i done a mistake in the CCM configuration.
Are you Voice CCIE?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide