MGCP and 4224

[dubrennan]

I have a 4224 using MGCP with the CCM. Their is also some brief H.323 config for SRST (allow outgoing 911 calls). I am having trouble getting dialtone on some of the FXS ports from CCM. I am also not able to make outgoing calls from the devices on the FXS ports after SRST runs in recovery mode and goes back to normal mode, though the FXS ports do recieve incoming calls still. Has anyone had any experience with this or had success with MGCP on the 4224?

[mimckee]

What does debug mgcp events show when the callmanager connection is restored? Do you see the 4224 trying to register back from the ccm. Is it all the ports or only some of the mgcp controlled ports?

-Mckee

[Nahid Mansoorian]

MGCP is not yet supported on 4224 platform. Some function may work and the command are there, however the full support for MGCP is not. So, you have to configure it for H323 for now. Hope this helps.