11-11-2005 11:11 AM - edited 03-13-2019 11:12 AM
Does anyone have a doc on how to wire an RCA connector (CD player, DirecTV etc) into an E&M port?
Solved! Go to Solution.
11-17-2005 11:57 AM
Hi
The required PINS on the E&M end are in the manual:
http://www.cisco.com/univercd/cc/td/doc/product/voice/its/cme33/cme33sa/cme33sys.htm#wp2183399
The other end will depend on what you're connecting to, but should be simple enough as audio outs only have a single pair of wires for each channel (you'd be best to take one channel and move the 'balance' control over to one side I imagine...)
Aaron
11-17-2005 09:32 AM
Try this document. It might help you.
http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_qanda_item09186a0080094766.shtml
11-17-2005 11:57 AM
Hi
The required PINS on the E&M end are in the manual:
http://www.cisco.com/univercd/cc/td/doc/product/voice/its/cme33/cme33sa/cme33sys.htm#wp2183399
The other end will depend on what you're connecting to, but should be simple enough as audio outs only have a single pair of wires for each channel (you'd be best to take one channel and move the 'balance' control over to one side I imagine...)
Aaron
11-21-2005 12:26 PM
I setup MOH via an E&M card and an external audio source - a bogen radio. I was able to get it to work, but the audio quality is awful. I must have done something wrong. Either there is a problem with my wiring or the impedance/ohm output of the radio is not matching the E&M port. According to Bogen the output is line level 600 OHM output. To try and solve this, I am also looking for the correct way to wire a cable to go from an RJ45 E&M port on the 2801 to a standard right and left RCA audio jack. Looking at the Cisco manual, it sounds simple, you just need to hook up pins 3 and 6. On the radio side for the line level output it uses Left/Right RCA jacks. From what I have read each side has a signal (pin) and a ground (jacket). How do I wire left signal, left ground and right signal, right ground (4 wires total) to just two pins on the E&M port? I have searched and searched and I cannot find anything. I would be happy to make my own cable if I just new how. Sorry for rambling.
02-15-2006 02:26 PM
Todh,
If you ever figured out a way to connect the E&M via RCA cable I would be happy to find out how you did it?
I too am going from a Bogen RM350D to the E&M on the 2811 router for the MOH and having the same issues you had in your post on NetPro.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide