network announcements at sip network.

[amos_shahar]

I'm using cisco GW 3500, sending traffic from SIP to H323

I have problems with toll-free numbers because they have "network annaoucements" - the "connected" signal is not sent and the timers expire by thr time the annaouncement end.

other numbers are working fine ( and toll-free numbers that don't have those announcements)

I want to replace the annaouncement signal with connected signal . (20O OK at the SIP).

I think the solution should be with the command "progress_ind" but no success yet.

here is the one of the dial-peers that I tried:

dial-peer voice 1800 pots

huntstop

preference 1

destination-pattern 18007623726

progress_ind progress enable 8

progress_ind connect enable 8

port 3/0:D

Thank You

Amos

[jbohla]

I have seen similar problems with international calls and toll-free numbers being disconnected... the problem was resolved by increasing T310 timers to 120000 msec.

[amos_shahar]

I getting to the DTMF menu but it is still in "ringing tone" mode , so even when I press the digits - it doesn't help . is there any way to transfer it through the signalling ?

Amos