I am installing Unity 3.1x on a ICS7750 after Exchange is installed I am getting errors in the Event Viewer listed below. I searched CCO, here, and MS Support and cannot find details, any ideas???? I have installed once with this error, rebuilt the server followed the instructions completely and still received this error?<br><br><br>EVENT: <br>Source: Perflib<br>Event ID: 1008<br>Type: Error<br>Description: The Open Procedure for service "ISAPISearch" in DLL "C:\<computername>\System32\query.dll" failed. Performance data for this service will not be available. Status code returned is data DWORD 0.<br><br><br>
How to stop Performance Monitor Errors in the Event Log
Without going into a huge discussion of the inner workings or limitations of Performance Monitor, this is actually expected. The errors are created when a windows components loads improperly or has erroneous information in the registry in its hook to Performance Monitor.
The errors can be quelled by either removing the Open value from HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\Services\:\Performance (your service may vary)
by changing the more global setting ExtCounterTestLevel down to something like 3 in the registry. (see Q226494, it also has a good explanation of the errors.)
If setting the test level for the performance counters still produces errors, setting the EventLogLevel registry value to 0 will stop all errors from being reported. This is not entirely recommended, but setting it to 1 or higher should reduce the amount of errors in most cases.
Anyhow, for more information, i will refer your attention to the following Microsoft Knowledge Base articles:
There are cases/situations where we have to configure custome CPTONE to resolve FXO disconnect issue. Following are situations which can arise due to FXO disconnect issue:
Phone A calls Phone B, Phone B does not answer. Phone A then goes on-hook but Phon...
Cisco announced major enhancements today to Webex Contact Center. Learn more about the highlights including
better support for the needs of large contact centers worldwide
improvements in the agent and cust...
SymptomsI’m doing a factory reset on the mobile board and it’s giving me the same issues that I wasn’t able to also send over last time. It says that it can’t connect to the server because of a firewall (we don’t have one) and then sometimes it...