Hi,
I have a problem with a VIC2-2BRI-NT/TE.I can receive
incoming calls but I can´t make outcoming calls.Only
can outcoming calls in a few seconds next that receive a incoming call or resetting the interface.
I know the bug of this cards but this is my configuration.
interface BRI0/1
no ip address
no ip route-cache
isdn switch-type basic-net3
isdn tei-negotiation preserve
isdn incoming-voice voice
isdn static-tei 0
sh version
Cisco IOS Software, C1700 Software (C1700-SV8Y7-M), Version 12.3(8)T, RELEASE SOFTWARE (fc
2)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2004 by Cisco Systems, Inc.
Compiled Thu 13-May-04 14:12 by eaarmas
ROM: System Bootstrap, Version 12.2(7r)XM2, RELEASE SOFTWARE (fc1)
lmicme uptime is 3 days, 1 hour, 9 minutes
System returned to ROM by reload
System image file is "flash:c1700-sv8y7-mz.123-8.T.bin"
Cisco 1760 (MPC860P) processor (revision 0x500) with 115006K/16066K bytes of memory.
Processor board ID FOC081729SP (40664178), with hardware revision 0000
MPC860P processor: part number 5, mask 2
1 FastEthernet interface
2 ISDN Basic Rate interfaces
4 Voice NT or TE BRI interfaces
32K bytes of NVRAM.
32768K bytes of processor board System flash (Read/Write)
Configuration register is 0x2102
sh isdn status
ISDN BRI0/1 interface
dsl 1, interface ISDN Switchtype = basic-net3
Layer 1 Status:
ACTIVE
Layer 2 Status:
TEI = 0, Ces = 1, SAPI = 0, State = AWAITING_ESTABLISHMENT
Layer 3 Status:
0 Active Layer 3 Call(s)
Active dsl 1 CCBs = 0
The Free Channel Mask: 0x80000003
Total Allocated ISDN CCBs = 0
Thanks for your help
