Avoid Pairing Failures
•
Pairing fails when you complete these steps in the wrong order. You must use AAI on your Cisco Cisco Show and Share appliance before you use AAI on your Cisco DMM appliance. Do not reverse this order or try to use AAI simultaneously on both appliances.
•Do not use the POP option on the pairing menu. Doing so may cause Cisco Show and Share to fail. If you accidently choose the POP option, you will need to re-pair the Cisco Show and Share and DMM appliances.
------------------
Pair Your Appliances
Procedure
Step 1 From the appliance that runs Cisco Show and Share 5.2:
a. Log in as admin to the Appliance Administration Interface (AAI).
b. Choose APPLIANCE_CONTROL > PAIR APPLIANCE.
c. Choose DMM.
 | Warning Do not choose any other option than DMM. |
d. Enter the fully-qualified domain name (FQDN) for your Cisco DMM appliance.
This is the DNS name. Do not enter an IP address.
e. Press Enter.
Your Cisco Show and Share appliance receives and successfully imports a digital certificate from your Cisco DMM appliance.
Step 2 From the appliance that runs Cisco Digital Media Manager 5.2:
a. Log in as admin to the Appliance Administration Interface (AAI).
b. Choose APPLIANCE_CONTROL > PAIR APPLIANCE.
c. Choose SHOW_AND_SHARE.
| Warning Do not choose any other option than SHOW_AND_SHARE. |
d. Enter the fully-qualified domain name (FQDN) for your Cisco Show and Share appliance.
This is the DNS name. Do not enter an IP address.
e. Press Enter.
Your Cisco DMM appliance receives and successfully imports a digital certificate from your Cisco Show and Share appliance.
--------------------
See Cisco Link :
