cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
357
Views
0
Helpful
1
Replies

Ringer Volume: Multiple DNs

craig.pollitt
Level 1
Level 1

I know you can change it for the entire device by using the Volume +/- when the handset is on hook. I also see where you can configure this under the Line appearance for Ringer Setting (Phone Idle & Active) to Disable, Flash, etc.

Is it possible to selectively adjust ringer volume per line on one device that has multiple DNs assigned to it?

Thanks.

Craig L. Pollitt

1 Reply 1

testeven
Cisco Employee
Cisco Employee

Hi!

The ring volume/level is saved on the phone's memory, therefore it will apply to the device as a whole, not on a line basis.

HTH!

Regards,

Teresa.

If it helps, please rate.

Regards, Tere. If you find this post helpful, please rate! :)