Ringer Volume: Multiple DNs

[craig.pollitt]

I know you can change it for the entire device by using the Volume +/- when the handset is on hook. I also see where you can configure this under the Line appearance for Ringer Setting (Phone Idle & Active) to Disable, Flash, etc.

Is it possible to selectively adjust ringer volume per line on one device that has multiple DNs assigned to it?

Thanks.

Craig L. Pollitt

[testeven]

Hi!

The ring volume/level is saved on the phone's memory, therefore it will apply to the device as a whole, not on a line basis.

HTH!

Regards,

Teresa.

If it helps, please rate.