11-21-2017 11:14 PM - edited 03-13-2019 10:05 PM
Hi,
we have two CUCM 9.1 & 11.0, need to communicate both CUCM End-users.
FYI. We were configured SIP TRUNK and router pattern, but no communication.
Solved! Go to Solution.
11-29-2017 12:31 AM
We were configured ICT, and it's working fine.
11-22-2017 07:16 AM
What troubleshooting steps have you taken?
Can you PING the sub of one cluster from the SUB of the cluster ?
After configuring the trunk did you make sure to save, apply config , reset?
What is the status of the trunk , top part of the trunk screen?
11-22-2017 09:45 AM
11-22-2017 07:46 AM
"no communication" doesn't provide any detail of what is not working to provide any assistance
signaling?
RTP?
call ring and drop?
11-22-2017 10:05 AM
11-22-2017 10:38 AM
Any FW's in between the two clusters?
A DNA run from each cluster going to a number on the other shows the call getting out correctly?
11-22-2017 11:10 AM
11-29-2017 12:31 AM
We were configured ICT, and it's working fine.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide