ephone 1(ext3519) calls on ephone 2(ext3525), upon successful connection ephone 1 puts ephone 2 on Hold.
After it: debug ephone error mac-address 0012.7f0f.3f8d, where mac-address belongs to ephone 1
gives the following:
...
7w0d: SkinnyGetCallState DN error -1
7w0d: SkinnyGetCallState DN error -1
7w0d: SkinnyGetCallState DN error -1
...
The appearance of the following line debug corresponds to signal beep of ephone 2
debug detail ephone 1 attached.
In spite of this error, the calls inner CME function normally, the problems begin in case the calls are made through dial-peer:
dial-peer voice 1000 voip
destination-pattern 0...
translate-outgoing called 1000
session target ipv4:192.168.5.254
dtmf-relay h245-alphanumeric
codec g711ulaw
ip qos dscp cs5 media
no vad
Upon pushing on hold by the talk through dial-peer voice 1000 it comes one-side audibility, the subscriber inner CME can hear, but inner dial-peer the subscriber CME does not.
How this error can be eliminated?
Thanks.