12-10-2001 11:21 AM - edited 03-12-2019 01:40 PM
I have searched this group for related topics and came up with no ideas, so I thought I would post. We are using the 1.2 softphone on CCM 3.1(2c). I have, I believe, the softphones configured correctly. I can say this because they work just fine sometimes (the lines appear) and then others they don't. I have tried rebooting the PC, the CCM, checked passwords (we are using the corporate directory with LDAP on CCM), verified that that TSP is correct in Phone and Modem options, etc, etc. all the things I have read to check, but this is intermittent. It may be related to using the corporate directory, but not sure. Anyone else have any consistent success with this?
12-16-2001 11:59 PM
Often times complex troubleshooting issues are best addressed in an interactive trouble-shooting session with one of our trained technical assistance engineers. While other forum users may be able to help, its often difficult to do so for this type of issue.
To utilize the resources at our Technical Assistance Center, please visit http://www.cisco.com/tac and to open a case with one of our TAC engineers, visit http://www.cisco.com/tac/caseopen
If anyone else in the forum has some advice, please reply to this thread.
Thank you for posting.
04-15-2002 07:19 AM
Hi,
I have a similar problem. CM 3.1 and IP softphone. no lines appear when I start up softphone. Did you fix this problem eventually? What's the solution?
Rgds,
Stuart
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide