SRST and transfer patterns

[svogt]

As suggested in

http://www.cisco.com/en/US/partner/products/sw/iosswrel/ps5207/products_administration_guide_chapter09186a0080392682.html#wp1349195

I need to configure transfer patterns to allow Cisco IP phones to transfer telephone calls from outside the local IP network to another Cisco IP phone.

The doc above states that wildcards are permitted.

When I use something like 4...., this is working fine. If using 4T, this is not working.

Question:

Is there a restriction regarding the wildcards allowed in the transfer patterns?

[kthorngr]

There aren't any restrictions that I know of for the wildcards allowed when in SRST. I have seen T used in the past. I am not able to test this at the moment though.

You might want to capture "debug voip ccapi inout" to start troubleshooting.

Kevin