SRST Outbound PRI

[cplatt01]

I am in SRST mode and cannot gain access to the PRI.

I am able to dial to the numbes associated with the PRI

I have the following commands in the fallback config:

access-code pri 9 direct-inward-dial

secondary-dialtone 9

Dial-peer voice 20 pots

destination-pattern 9T

incoming called-number

direct-inward-dial

port x/x/x

Also, incoming calls work fine.

[johncaston_2]

I suggest that you run the debug voice dialpeer command to see what's happening. I suspect you may need to have an outgoing profile associated with the dialpeer, that's what the debug indicated to me and when I created the profile I could then dial out in SRST mode for both PRI and BRI

Here's the relevant entries;

voice translation-rule 2

rule 1 /^1/ // type any unknown

voice translation-profile OutBound

translate called 2

dial-peer voice 11 pots

translate-profile outgoing OutBound

destination-pattern 1T

direct-inward-dial

preference 1

port 0/0/1

call-manager-fallback

transfer-pattern 1T

transfer-pattern 64..

secondary-dialtone 1

I don't have the access-code line on my config

Let me know if you still have no luck and I'll dump down the entire config for you to have a look at.

Good luck,

John

[cplatt01]

I will give it a try. Thanks for posting.