Hi Folks,
Just installed a VG200 with 2 port T1. T1 1/0 is going to a Nortel PBX and is set up as AMI, SF, and internal clocking. T1 1/1 is going to a Telco and is set up as AMI, SF, and line clocking. I'm getting slips on T1 1/0. I've swapped the T1's around and I get the same thing. I put them back, set T1 1/1 to clock source line primary, still no help. The Nortel guy says that his side is set to line, but he doesn't know how to set it as internal, so I have tried that. I haven't found any documentation on CCO that states that the T1 with line clocking would redistribute to the T1 with the internal clocking. Could anyone point me in the right direction?
Thanks
Mark
