VG248, slow modem speeds

[p.hanagan]

Has anyone managed to get a VG248 to connect a V.90 modem at greater than 33K ?, I have several modems on a VG248 going out of a 2600 g/w on the same subnet (simple modem passthrough), when using an ATA186 (not supported I know !!) the modems connect at 56K ?.

Thanks

Paul

[dgoodwin]

Paul, have you tried this using VG248 software version 1.2(1)? Also, what are the port specific parameters configured for on the port?

[p.hanagan]

The version of code is version 1.1(2.29) - A TAC special !. I did not release that 1.2.(1) is out, I will download and check this out. The port specific parameters have Fax relay disabled:-

Status (enabled)

Call control mode (standard)

Caller ID (enabled)

MWI method (lamp)

Call supervision method (none)

Input gain (0)

Output gain (0)

Dialing digit detection (default: use DSP)

Fax relay (disabled)

Fax relay ECM (disabled)

Fax relay NSF (preserve value)

Passthrough mode (default: automatic)