04-17-2006 05:55 AM - edited 03-13-2019 12:55 PM
Hi,
I am using VG-248 with analog phones and CCM version 4.1.3. I just want to use FAC Codes for dialout to ISD nos.
Does this VG-248 supports CCM Forced Authentication Codes.
Thanks in advance.
04-17-2006 06:22 AM
Sure, you can use FAC with VG-248 phones.
Make sure your route patterns have FAC enabled and set the CSS and partitions for the VG248 phones to use those route patterns.
Regards,
Anup
04-17-2006 07:00 AM
Hi Gautam,
Have a look at this info for FAC and CMC for CCM 4.1.3. Here is an excerpt from the guide:
"The CMC and FAC features work with all Cisco IP Phone models and MGCP-controlled analog gateways."
From this doc:
Cisco CallManager Features and Services Guide, Release 4.1(3)
Client Matter Codes and Forced Authorization Codes
Hope this helps!
Rob
Please remember to rate helpful posts.......
04-17-2006 09:20 AM
Hi Rob,
Thanks for the reply. But i want to connect Analog phones to VG248 gateway and the VG248 will remain registered with CCM 4.1.3.
Then will FAC work with analog phones. Thats what my query is. Helpful if I can get some link for configuring the VG248 also for analog phones.
Thanks in advance.
04-17-2006 10:33 AM
Yes, FAC will work with analog phones connected to VG248.
Here is the link to config guide for VG248
http://www.cisco.com/univercd/cc/td/doc/product/voice/c_access/apg/vg248/v1_3/swcfg/index.htm
Regards,
Anup
04-17-2006 11:02 AM
Hi Anup,
Thanks for the prompt response. Will try it tomorrow morning and post the rating.
Thanks.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide