09-30-2009 08:52 AM - edited 03-15-2019 05:10 AM
pls help as to how can i configure a pvdm on a voice gateway to be use to terminate voice(tdm to voip)
thanks
09-30-2009 09:30 AM
There is no config for that, once the PVDMs are loaded and the PRI/FXS/FXO is loaded by the IOS it allocates the necessary channels
HTH
java
if this helps, please rate
09-30-2009 10:19 AM
But what if it is beeing used also as trancoder?
09-30-2009 10:24 AM
Not sure what you mean if you don't provide a clear explanation
If you mean you want to share voice termination and XCODER it's possible (As long as you have enough DSPs for both of course)
HTH
java
if this helps, please rate
09-30-2009 10:30 AM
Hi Celso,
Sorry for not follow up the other post about this topic.
As Java said, it doesn't need configuration.
To answer your last question:
You allocate DSP resources either to voice termination of the voice trunk group or to the DSP farm. Occasionally these allocations can conflict.
If you previously allocated DSP resources to voice termination (this must be done first) and you now try to configure a DSP farm, you might find that insufficient DSP resources are available. Conversely, if you previously allocated DSP resources to a DSP farm and you now try to configure a trunk group, you might find that insufficient DSP resources are available.
Hope it helps, if it does please rate.
Best regards,
- Adrián.
09-30-2009 11:03 AM
is it possible to provide sample configuration of the above mentioned scenario?
thanks
09-30-2009 11:09 AM
Configuring Enhanced Conferencing and Transcoding for Voice Gateway Routers
http://www.cisco.com/en/US/docs/ios/12_3/vvf_c/interop/intcnf2.html
Capacity planning and full explanation is on the link.
HTH
java
if this helps, please rate
09-30-2009 06:52 PM
hi java,
i couldnt see any config of mix voice termination and transcoder/conf bridge.
09-30-2009 08:59 PM
again... there is NO config for voice termination. Adrián also explained this.
You DO NEED to configure XCODER or CFB, for that, refer to the link
HTH
java
if this helps, please rate
09-30-2009 10:38 PM
pls have a look on my other post titled
'pvdm2 enable on 2800 main board'
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide