Hi All,We are facing a problem while making PSTN calls to outside world using Cisco 2800 router configured as H.323 Gateway & integrated to Call Manager version 4.x.On the router we have , VWIC-2MFT-E1 card on which PRI is terminated.Setup was worki...
Right now our Callmanager was set to a default state and we want to change it for security reasons. Is this possible and what are the steps in making this happen?In addition is it easier to change the password vs. the profile?
do we require the below command if the dsp is installed on the main board like the 2800 series..voice-card slotif not then how is the pvdm2 enabled on the board?thanks
hi friends,is there any service we can create to add contact numbers by phone itself.is there any free software is there for ccme.in the phone itself if u click press service button it has to give add option and search option to add and delete contac...
Hi all,I am trying to change the network speed on a 7960 however when I try to access the "network setting" menu on the phone it is grayed out. I have enable the "Settings Access" on CM, reset phone, and tried unlock using **# to no avail. I have jus...
Hi,I am planning to install a Avaya IP Phone on a Cisco POE Switch 3560. I know it will work with proper configuration. I like to know the non-compatibility issues or drawbacks using both. Please provide me a document says this so that I can finalize...
I am little bit confused with this topic. I need a report which displays all the calls made by users on daily basis. When I see in the discussion forums, people are talking about CAR tools but I am not sure if it can be used in CUCM 7 or not. When I ...
hi everybody, i need configure the general manager phone's with this, when someone call him all his calls must transfer to his secretary, depending who is calling the secretary transfer to his boss again, i use the CFwdALL in the general manager phon...
When I do a search by directory number->begins with 559 I only receive (46) 55900-55926 results. I should be receiving over 80. It won't show anything that starts with 55927 and up, which should show up in the original search of anything that begin...
Hi,Have CUCM 6.x with service parameter 'CDR Enable Flag' set to TRUE.I changed the value for this parameter 1 month ago thus CDR flat files had to be collected.Today I added external SFTP billing server via 'Serviceability | CDR Management' interfa...
