My C3660 have a NM-HDV-1E1 (voice-port 1/0:15) and 4 fxo pots. All these ports connect to a PBX.
Problem is:
From voice-port 1/0:15, can dial to remote site (not via ccm), from fxo ports can dial IPphone (via CCM), but from voice-port 1/0:15, cannont dial to IPphone (via CCM), and the IPpone can dial to this port.
Some configuration is:
voice-card 1
dsp services dspfarm
!
isdn switch-type primary-net5
!
!
voice call send-alert
voice rtp send-recv
!
voice service voip
h323
h245 caps mode restricted
!
!
voice class codec 1
codec preference 1 g729r8 bytes 30
!
voice-port 1/0:15
cptone CN
!
voice-port 3/0/0
supervisory disconnect anytone
cptone CN
timeouts call-disconnect 5
!
voice-port 3/0/1
supervisory disconnect anytone
cptone CN
timeouts call-disconnect 5
!
voice-port 3/1/0
supervisory disconnect anytone
cptone CN
timeouts call-disconnect 5
!
voice-port 3/1/1
supervisory disconnect anytone
cptone CN
timeouts call-disconnect 5
!
!
!
!
dial-peer cor custom
!
!
!
dial-peer voice 500 voip
destination-pattern 2....
session target ipv4:122.11.30.2
!
dial-peer voice 105 pots
destination-pattern 3
direct-inward-dial
port 1/0:15
prefix 83938392#
!
dial-peer voice 300 pots
destination-pattern 4
port 3/0/0
!
dial-peer voice 301 pots
destination-pattern 4
port 3/0/1
!
dial-peer voice 310 pots
destination-pattern 4
port 3/1/0
!
dial-peer voice 311 pots
destination-pattern 4
port 3/1/1
!
dial-peer voice 700 voip
destination-pattern 0T
voice-class codec 1
session target ipv4:83.6.12.2
!
num-exp 1.... 0181....
num-exp 0183.... 3....
!
Thanks,
Yangsir
