05-19-2015 06:51 PM - edited 03-01-2019 07:54 AM
Hello everyone,
Hopefully someone can help me, I have a 4506 catalyst switch with WS-X4516 Supervisor Engine V link below,
when I boot up the switch it is at "rommon1" prompt, what firmware should I download, I am new student learning, your help will be greatly appreciated.
Thank you
James
Solved! Go to Solution.
05-19-2015 11:35 PM
give "boot" command in "rommon 1" prompt.
if still not working then need to see the config-register value.
05-19-2015 11:35 PM
give "boot" command in "rommon 1" prompt.
if still not working then need to see the config-register value.
05-31-2015 11:16 AM
Posts in this discussion have been removed due to possible misconduct. Please refer to the CSC terms of use for more details. https://supportforums.cisco.com/document/29951/cisco-support-community-acceptable-use-agreement
The Cisco Support Community
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide