Hi,
i'm using cisco fet-10g sfp moduls and all these modules are in validation faild status.
changing the portspeed for example to 1G and back to 10G wont fix it.
anyone any ideas?
_____________________________________________________________________________________
sh int brief
--------------------------------------------------------------------------------
Ethernet VLAN Type Mode Status Reason Speed Port
Interface Ch #
--------------------------------------------------------------------------------
Eth1/1 1 eth access down SFP validation failed 10G(D) --
_____________________________________________________________________________________
sh int status
--------------------------------------------------------------------------------
Port Name Status Vlan Duplex Speed Type
--------------------------------------------------------------------------------
Eth1/1 -- sfpInvali 1 full 10G 1/10g
_____________________________________________________________________________________
# sh interface e1/1 transceiver
Ethernet1/1
transceiver is present
type is Fabric Extender Transceiver
name is CISCO-JDSU
part number is PLRXPL-VC-S43-CD
revision is B
serial number is JUS1518A135
nominal bitrate is 10300 MBit/sec
Link length supported for 50/125um fiber is 20 m
Link length supported for 50/125um fiber is 100 m
Link length supported for 62.5/125um fiber is 10 m
cisco id is --
cisco extended id number is 4
_____________________________________________________________________________________
sh interface e1/1
Ethernet1/1 is down (SFP validation failed)
Hardware: 1000/10000 Ethernet, address: 547f.ee05.e208 (bia 547f.ee05.e208)
MTU 1500 bytes, BW 10000000 Kbit, DLY 10 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA
Port mode is access
auto-duplex, 10 Gb/s, media type is 10G
Beacon is turned off
Input flow-control is off, output flow-control is off
Rate mode is dedicated
Switchport monitor is off
EtherType is 0x8100
Last link flapped never
Last clearing of "show interface" counters 01:11:57
30 seconds input rate 2784 bits/sec, 348 bytes/sec, 0 packets/sec
30 seconds output rate 0 bits/sec, 0 bytes/sec, 0 packets/sec
Load-Interval #2: 5 minute (300 seconds)
input rate 2.27 Kbps, 0 pps; output rate 0 bps, 0 pps
RX
0 unicast packets 1419 multicast packets 0 broadcast packets
1419 input packets 1494583 bytes
0 jumbo packets 0 storm suppression bytes
1 runts 0 giants 0 CRC 0 no buffer
1 input error 0 short frame 0 overrun 0 underrun 0 ignored
0 watchdog 0 bad etype drop 0 bad proto drop 0 if down drop
0 input with dribble 0 input discard
0 Rx pause
TX
0 unicast packets 0 multicast packets 0 broadcast packets
0 output packets 0 bytes
0 jumbo packets
0 output errors 0 collision 0 deferred 0 late collision
0 lost carrier 0 no carrier 0 babble
0 Tx pause
0 interface resets
