UCS command to start it automatically

[Gabriel Castro H]

Hello guys,

We some UCS but we have the problem that when the eletricity goes down the server too, but they do not start automatically after the electricity come.

I have been looking for some command in the bios to do this automatically but I have not had successful getting it.

I will appreciate your help, if some can help me with this or is not possibility to get this please let me know !

Thanks,

Gabriel

[richbarb]

Hello Gabriel,

You may change the desired power state settings in the service profile, BEFORE apply that service profile to a blade.

Richard

[Gabriel Castro H]

Hello Richard,

Thanks for your response, we have is a UCSC-C220-M3l is the same way to check this or is it different ?

I am new working with this devices so I really appreciate your help !

Thanks in advance,

Gabriel

[richbarb]

Hello Gabriel,

This procedure that I mentioned before is only to B-Series, I supposed that you was talking about B-series.

The C-Series you can follow this guide below. ( I don't have a C-Series screenshot right now to show you).

http://www.cisco.com/en/US/partner/docs/unified_computing/ucs/c/sw/gui/config/guide/1.4.1/b_Cisco_UCS_C-Series_GUI_Configuration_Guide_141_chapter_011.html#task_053D569DACBF499C85E9F4F75CEF4B1F

Regards.

Richard

[Gabriel Castro H]

Hi Richard,

Thanks for your fast reponse, I am going to check this in our device !

I will keep you posted.

Thanks,

Gabriel