09-20-2012 08:35 AM - edited 03-01-2019 07:10 AM
Hi everyone,
Could anyone could tell me why I can't bring up the link between 7K and 3750 using the following:
7K: 1000base -LH
3750: 1000base-LH
My interface would not come up, I tried to change the speed to the interface on the 7K, it comes back with the error
"ERROR: Ethernet ##, configuration does not match the port capability"
Thank you for the help.
Solved! Go to Solution.
09-24-2012 10:24 AM
OK.. N7K-M132XP-12 is 10G only card
09-24-2012 05:51 AM
Looks like you have a 10G only capable interface. But you can do show interface ethernetx/y capabilities to check.
Here is an example
20-11-7010-N7k-Core-A# conf
Enter configuration commands, one per line. End with CNTL/Z.
20-11-7010-N7k-Core-A(config)# int eth1/8
20-11-7010-N7k-Core-A(config-if)# speed 1000
ERROR: Ethernet1/8: Configuration does not match the port capability.
20-11-7010-N7k-Core-A(config-if)# sh int ethernet 1/8 capabilities
Ethernet1/8
Model: N7K-M132XP-12
Type (SFP capable): 10Gbase-(unknown)
Speed: 10000 <<<--------
09-24-2012 09:38 AM
Here is the snapshot:
NX7K01# sh int ethernet 7/25 capabilities
Ethernet7/25
Model: N7K-M132XP-12
Type (SFP capable): 1000base-LH
Speed: 10000
Duplex: full
Trunk encap. type: 802.1Q
FabricPath capable: no
Channel: yes
------------
09-24-2012 10:24 AM
OK.. N7K-M132XP-12 is 10G only card
08-12-2020 06:57 PM
09-24-2012 12:29 PM
Thank you Krishn. Got it.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: