07-06-2004 09:08 AM - edited 03-02-2019 04:52 PM
Consol in durring boot sequence and it only gets this far.
Self decompressing the image : #################################################
############################################################ [OK]
Smart Init is enabled
smart init is sizing iomem
ID MEMORY_REQ TYPE
MainBoard 0X00027A80 1760
0X000F3BB0 public buffer pools
0X00211000 public particle pools
0X002E 0X0001B800 Card in slot 0
TOTAL: 0X00347E30
If any of the above Memory Requirements are
"UNKNOWN", you may be using an unsupported
configuration or there is a software problem and
system operation may be compromised.
Allocating additional 655793 bytes to IO Memory.
PMem allocated: 29458463 bytes; IOMem allocated: 4095969 bytes
program load complete, entry point: 0x80008000, size: 0x67064c
any ideas? Thanks
James
07-06-2004 09:50 AM
also Ctrl + Break is not letting me in I have hit it within 10 seconds of beginning of boot
James
07-06-2004 11:04 AM
James,
I wanted to verify what IOS version and feature set you were running and how much DRAM memory you have? Does the 1760 boot without any modules installed?
07-06-2004 11:36 AM
no it will not boot with out WICs....
it has 16/32 on memory and I am running a single ADSL wic and
C1700-y7-mz.123-9.bin is the IOS version
07-06-2004 12:38 PM
That IOS requires 48MB of Dram and 16MB of flash. Confirm you have up to this,
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide