Hi guys,Is it possible that 2x serial interfaces use the same "ip unnumbered fa0/0"?If yes, does it mean i'm effectively doing some kind of static route load balancing between the 2 links?Thanks,Steven
Hi,My internet provider company doesn't offer t1 line in my area. So, I have to buy 16 analog lines. Which VIC card would I need for my 2651xm cisco router? And any additional card(s) would be necessary?Thanx,
HiWe are in the throws of installing a couple of 3550 (EMI) switches running HSRP for failover, off these units we will install 9+ 2950 & a couple of 2970's. We need to have the two 2970s working in failover mode similar to HSRP on the 3550's, I unde...
I have (3) 2980G-A switches and (1) 3750 gigabit switch. Each 2980G-A has a pair of copper GBIC's. What is the best way to connect all of the GBIC's to the 3750? The IOS on the 2980G-A is 6.x. Will the current IOS work with my older 2980G-A?
Does anyone knows how to recover or change the admin password for ciscoworks. The default was changed during installation but the installer has now forgotten the new password. Server is solaris.
After installing the LMS 2.2 package I have to update it with the various patches and get update-1 installed. Is there a document that clearly states what is necessary to get the installation up to date? Something in the order of install IDU 5.0 then...
Hi,Need help! Can anyone advise if there exists any tools available that can monitor network activities on individual switch port and generate report advising for how long there have not been any activities on that ports?
I'm trying to setup some kind of notification to occur when a downstream switch loses connectivity and would really appreciate any advise on the matter.Here's a very rough diagram of my current setup:core-6500 ------ CiscoWorks | |-- distribution-3...
I have a 1760 behind a pix 515e. The 1760 has 2 interfaces. INF0/0 is facing my network and INF1/0 is facing my PIX. My Pix has 3 interfaces. PIX0/0 is facing the internet with a public IP, PIX1/0 is the default gateway for my network with a priv...
After I connect 2 Catalyst4500 switches with each Giga Ether port with a crossover cable only crossover the 1/3, 2/6, when I use Show Interface, it still reports that the port is 1000M with Full duplex. Can the switches work properly in this case?But...
I am trying to verify that a Catalyst 2950C can use single-mode fiber as well as multi-mode. I am pretty sure it only accepts single-mode but I want to verify this and all tech specs docs only talk footage (which equals out to MM). Any help as to a d...
SQL Client PC attached to LAN port of 1721 router at remote T1 site unable to access port 1433 on SQL Server on LAN port of a 1721 on the local site. NETSTAT showed the Local Address port 1042 accessingSQL Server port 1433 State of TIME_WAIT.Same PC...
I thought about using customer queueing but you need to be able to assign traffic types by protocol type, so this isn't possible with EIGRP.Any other ideas?
