01-05-2005 07:36 AM - edited 03-02-2019 08:54 PM
I have a used switch, 2950..
I have having trouble, with password recovery.
I have used " break ", and " ctrl break " both to interupt during the boot process. However, I cannot get it to work.
Does anyone have any suggestions!!??
Thanks in advance..
01-05-2005 07:43 AM
What operating system and application do you use to console? Break sequence depends on it
http://www.cisco.com/warp/public/701/61.html#topic1
Also, make sure you are following the password recovery procedures
01-05-2005 08:02 AM
Thank you.
I have it figured out, I was about to get back on, and let the forum know.
I do appreciate the helpful links though..
thanks again,
Tony
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide