2950 Switch and QoS

[gserghiou]

Hi all,

I would like to configure this switch to give high priority and switch data from a given port first.

In more detail i would like to deal with data (voice) that comes on a certain interface first, where the VoIP card of a PBX system is connected to.

I can then prioritise the traffic on my router, but i would also like it to be the first to be processed on the switch.

Any ideas appreciated.

Thanks,

George

[pflunkert]

Hi George,

the configuration guide will help you:

http://www.cisco.com/en/US/products/hw/switches/ps628/products_configuration_guide_chapter09186a00801cdef0.html

The most thinks you can do on a cat 2950, but you must differ between the images. With the SMI Image you can't do all.

Regards

Peter