09-21-2006 06:05 AM - edited 03-03-2019 05:10 AM
hi,
I have a big problem with a 4507R catalyst switch(The all port are 1Gb).
When I configure a port to 1G, this port connect, disconnect,connect, disconnect ...
But when i configure this port to 100M it's ok.
The pb is that the all port are busy, i don't have a free port to pluged the cable.
I can't restart the catalyst.
Please help me!! because it's very urgently!!
It exist a solution without restart....
In advance thank you
09-21-2006 06:56 AM
Hi,
Did you try to set auto on the switch port and the server?
09-21-2006 08:17 AM
Hi,
I have always the same pb.
Please help me!!
09-21-2006 08:33 AM
Sure you have a cat 6 8 wire patch cable . Gig takes all 4 pairs of wires to run correctly . I also have always left the port as auto to runn gig . Also if you hardcode the switch you have hardcode your nic too .
09-22-2006 12:35 AM
Yes, the cable is ok.
I have tested with an other cable and i have the same pb.
Please help me
09-22-2006 01:06 AM
set speed/duplex to AUTO on 4507 port and server NIC.
Then shut the interface and then no shut.
see if it helps ...
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide