Bandwidth

[rajankumaresan]

We hv 2mb LL (fiber) from our ISP..Can we assign 128K to one Network segment and remaining b/w to the other network . ( Routers E0 and E1 is diff network ( cisco 2621 ))

[mmikhail]

Yes. You can configure rate limiting. Read http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122cgcr/fqos_c/fqcprt1/qcfcar.htm

[r.kumaresan]

i hv configured rate-limit for input and outputs with a burst limit of 8000 for max and min..

do i need to give access group cmd in the particular interface..

i hv given access-list rate-limit 101 then MAC of the interface

[daipayan_b]

Hi,

configure access-lists based on destination subnet on which you want only 128kbps and apply on the Serial Interface (2 mb LL)with the burst size (both min and max) to 128k.

hope this helps.

[rajankumaresan]

what i did was,i hv configured at ethernet 1 interface - rate-limit for input and output with a min and max burst ...then access list in global mode..

what i shd do in Serial interface?