I have set a number of static cam entries on a catalyst 6000 for multicast services, during a topolgy change these cam entries are cleared along with the dynamic entries, should this happen ?Also will the same occur during igmp snooping ?
I 'am looking for a good description for MPLS/VPN we want use ISIS and BGP as Routing Protocols.What we also need is a detailed description of a Configurtaion example.Can provide such informations.
I'm connected to a cable ISP and have the 1604 connected behind the cable modem. I currenly have my PC obtain a DHCP lease and then plug the IP address into the router and it works (with a spoofed MAC), but is there a way to have the router do this o...
When entering show flash on my 7206vxr router I get: Open device slot0 failed (No device available) If I try to reformat it I get Error formatting slot0: (Unspecified error)sh ver output:Cisco Internetwork Operating System SoftwareIOS (tm) 7200 Softw...
I have a Vip with two sigle port Fast Ethernets cards that are in a 7513 that I want to use in a 7505. Asside from IOS will the VIP with fastethernets work in a 7505?
I am having trouble finding a part number of a PRI card for a 7500 router. I am assuming they make one or one was made at some time. Also, is they do, does it have a built-in CSU?
Here is the message in full:Jan 17 15:02:51: %SYS-3-CPUHOG: Task ran for 8474 msec (18/7), process = Net Background, PC = 8032F0F8.-Traceback= 8032F0FC 802FC1D8 80340D70This message was received on a Cisco 2600 router, at the time the router was disc...
Is it true, that a file is TFTP downloaded first into RAM, then the supported platform is verified, checksum is verified and after that flash is erased (if needed)followed by the writing process?
cisco7200VXR with two PA-MCX-8TE1,IOS version 12.2(6)(IOS (tm) 7200 Software (C7200-JS-M)).when boot the system,it appear the prompt:%PA-2-UNDEFPA: Undefined Port Adaptor type 378 in bay 1、%PA-2-UNDEFPA: Undefined Port Adaptor type 378 in bay 2%PA-3-...
I have Cat 6509s running and want to insert some new modules. However, I have been unable to find a definitive answer as to whether the insertion of new modules will result in other interfaces on the switch taking a hit when I install the new modules...
I have 2620 at the remote site with two pvc's. At the head end, I have a 7206 router connected to a 4006 switch with a rsp card with separate vlans. The Call Manager is on vlan 20. How do I configure the routers to have voice only on one pvc and data...
