12-08-2003 09:19 AM - edited 03-02-2019 12:12 PM
Hello:
MY problem is two cat6509 run hsrp authentication no work.ADD other cat6500 setting standby xxx priority 150 "sh stan" is R3 standby?
R1
interface Vlanxx
ip address xxx.xxx.xxx.1 255.255.255.0
no ip redirects
no ip unreachables
standby xxx priority 200 preempt
standby xxx authentication cisco
standby xxx ip xxx.xxx.xxx.xxx.254
R2
interface Vlanxx
ip address xxx.xxx.xxx.2 255.255.255.0
no ip redirects
no ip unreachables
standby xxx priority 120 preempt
standby xxx authentication cisco
standby xxx ip xxx.xxx.xxx.xxx.254
R3
interface Vlanxx
ip address xxx.xxx.xxx.3 255.255.255.0
no ip redirects
no ip unreachables
standby xxx priority 150
standby xxx ip xxx.xxx.xxx.xxx.254
Thank you !!!!
12-09-2003 06:40 AM
Probably the best thing to do would be to debug HSRP and see what is going on , config on quick look appears ok assuming you are going between r1 and r3 . If you are trunking make sure your vlan is allowed acros the link . Can you ping between the .1 and the .3 ? You should be able to .
12-09-2003 06:24 PM
I Try test debug HSRP :
*Dec 3 11:32:28.583 HKT: SB252: Vl252 Hello in r1 Active pri 200 ip xxx(r1)
*Dec 3 11:32:29.139 HKT: SB252: Vl252 Hello in r3 Standby pri 150 ip xxx(r3)
R1 ,R2 ,R3 is trunking allowed all vlan.
So R3 said is standby router.
Thank!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide