04-30-2003 07:55 AM - edited 03-02-2019 07:01 AM
All my catalyst 4000 switches are grouped as uncertified system instead of switches. Do I need a patch for DFM?? If so, wich one do I need??
04-30-2003 09:23 AM
Have you applied the DFM 1.2 IDU 1.2.4 patch from CCO:
http://www.cisco.com/cgi-bin/tablebuild.pl/cw2000-dfm
Most of the new switches are supported with the above IDU per:
http://www.cisco.com/univercd/cc/td/doc/product/rtrmgmt/cw2000/dfm/dev_sup/dfm1_2.htm#60303
05-02-2003 07:39 AM
Thank you, I have installed this patch and only one device is regrouped as a switch. It is a catalyst 4503, but I have a Catalyst 4506 and a Catalyst 4006 device that remain as "uncertified system".
The sysobjectID for the Catalyst 4006 is "1.3.6.1.4.1.9.1.448" but this is not listed in the devices supported with IDU 1.2.4
05-02-2003 02:00 PM
.448 is the sysObjectID for Sup-IV (WS-X4515). Does this Cat4006 has WS-X4515 in it?
05-05-2003 06:55 AM
No. It has a X4014 (SUPIII), and the other catalyst device (WS - C4506) has a WS -X 4013 (SUP II). Could this be the problem??
05-05-2003 11:43 AM
From: http://www.cisco.com/univercd/cc/td/doc/product/rtrmgmt/cw2000/dfm/dev_sup/dfm1_2.htm
Note 3 says, DFM supports the Catalyst 4000/4500 Supervisor Engine IV (WS-X4515) on the C4503, C4506 and C4507. DFM supports the Catalyst 4000 Supervisor Engine III (WS-X4014) on the C4503 and C4506.
05-06-2003 07:50 AM
Yes, but what should i do if the systemobjectID doesn´t appear in the list of supported devices by IDU 1.2.4 ??
05-06-2003 11:53 AM
Then it's not supported by IDU 1.2.4
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide