Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HI, I´m new to WLSE. My AP´s are already discovered and managed, but when I try to download the configuration archive from them, the Job Always fail with a SNMP timeout error message. This problem occur in the upgrade firmware job too.Whe I go to rep...
Hi, I am having an extremely high Multicast and Broadcast traffic rate on my LAN. We recently installed our Checkpoint FW on a Cluster high availability scheme and the problem started, I dont know if it´s got something to do with it. I had to enabl...
When configuring a repeater access point, the log file displays the following messages: "associated to parent [aaaa]""reassociate response from parent [aaaa]"several times in a second (never stop), and the following warning message appear:"failed to ...
I have an 1200 series AP, and when i try to associate it as a repeater, it associate and disassociate many times per second, and after a while, it gets blocked or shuts down. I have configured the same authentication type for both (root and repeater)...
Before, when a switch was DOWN, it was reported as "switch - Unresponsive" in device fault manager 1.2 monitoring console. Now, when a switch is down it is not reported inmediately, but is reported as "SNMPAgent - Unresponsive" after a longer time pe...
Thank you, I have installed this patch and only one device is regrouped as a switch. It is a catalyst 4503, but I have a Catalyst 4506 and a Catalyst 4006 device that remain as "uncertified system". The sysobjectID for the Catalyst 4006 is "1.3.6.1.4...
Thanks for your help, I recently upgrade to 12.0(5.3)WC(1) and I will test tomorrow. Thanks for your help, I also agree with the console topic, I have never heard that before. Thanks David.
