catalyst 4000 devices are listed as uncertified systems in DFM 1.2

[gestmng]

All my catalyst 4000 switches are grouped as uncertified system instead of switches. Do I need a patch for DFM?? If so, wich one do I need??

[rmushtaq]

Have you applied the DFM 1.2 IDU 1.2.4 patch from CCO:

http://www.cisco.com/cgi-bin/tablebuild.pl/cw2000-dfm

Most of the new switches are supported with the above IDU per:

http://www.cisco.com/univercd/cc/td/doc/product/rtrmgmt/cw2000/dfm/dev_sup/dfm1_2.htm#60303

[gestmng]

Thank you, I have installed this patch and only one device is regrouped as a switch. It is a catalyst 4503, but I have a Catalyst 4506 and a Catalyst 4006 device that remain as "uncertified system".

The sysobjectID for the Catalyst 4006 is "1.3.6.1.4.1.9.1.448" but this is not listed in the devices supported with IDU 1.2.4

[rmushtaq]

.448 is the sysObjectID for Sup-IV (WS-X4515). Does this Cat4006 has WS-X4515 in it?

[gestmng]

No. It has a X4014 (SUPIII), and the other catalyst device (WS - C4506) has a WS -X 4013 (SUP II). Could this be the problem??

[rmushtaq]

From: http://www.cisco.com/univercd/cc/td/doc/product/rtrmgmt/cw2000/dfm/dev_sup/dfm1_2.htm

Note 3 says, DFM supports the Catalyst 4000/4500 Supervisor Engine IV (WS-X4515) on the C4503, C4506 and C4507. DFM supports the Catalyst 4000 Supervisor Engine III (WS-X4014) on the C4503 and C4506.

[gestmng]

Yes, but what should i do if the systemobjectID doesn´t appear in the list of supported devices by IDU 1.2.4 ??

[rmushtaq]

Then it's not supported by IDU 1.2.4