Configuration required in Cat 4006 to forward errors to syslog server

[raju]

Hi,

I have setup a Kiwi syslog server. I want to configure in my Cat 4006 switch to forward the following messages to my syslog server

1. configuration changes

2. Vlan creation /modification

3. Power supply failures/module failures/temperature

4. When the processor utlization exceeds more than 75% , it should send a alert message to syslog server

5. Switch restart

6. Trap for any changes in Uplink ports only. There are 4 uplinks to other Switches from 4006. If any problem with these ports (uplink), it should send message to syslog server , not for all ports

Thanks in advance

Raju

[spremkumar]

Hi

I feel this link will be of some help to u in configuring different severity levels for different facilities available.

http://www.cisco.com/en/US/partner/products/hw/switches/ps663/products_configuration_guide_chapter09186a00800d81c8.html

By default for abnormal temp conditions u will get logs in the syslog server if u have already pointed the logs to the syslog server..

regds

[raju]

Thanks edwin. It was a useful link.

Regards,

Raju

FSS