05-14-2003 06:24 AM - edited 03-02-2019 07:20 AM
My planning network
Switch(WS-3550-SMI) VLAN 1(192.168.1.1)&VLAN2(192.168.2.1) ---inside(192.168.1.10)PIX(10.10.10.1)outside-----(10.10.10.2)router---Internet.
My switch will do the intervlan routing.Both segments is able to communicate to each other.
My question is how should I configured inorder for all my workstations to access internet on both segments.
Which IP gateway should use on workstation on both segments?
05-14-2003 07:54 AM
Hi
Best is to have the 3550 as you Gateway for each VLAN. So that mean's
for host on VLAN 1 it's 192.168.1.1 and for host on VLAN 2 it's 192.168.2.1.
You also have to implement a Default Route on the 3550 towards the PIX like
ip route 0.0.0.0 0.0.0.0 192.168.1.10 ==> on 3550
On the PIX you have to route your internal networks, in this case only the
192.168.1.0 Network.
This way you only can create new VLAN's and just add a route on the PIX for the network.
Hope that helps
Roger
05-14-2003 08:24 AM
I totally agree with this. Just to add on 2 x C3550 switches. Both should run as VTP server hence VLANs are backed up. If you can get C2550 - EMI, you can run HSRP and that address will be your default gateway. If you have 2 router one router to one switch and the other to second switch. In case if 1 switch fails your network will not fail. Your network is reliable, your VLANs are present and your job is secure. By having only 1 VTP server switch can be a single point failure.
Thanks
05-15-2003 06:19 AM
I am getting the idea.
Should I put in this command in the PIX as you metioned
route outside 0.0.0.0 0.0.0.0 10.10.10.2.
Anymore routing command required on the router,PIX and switch
Pls advise.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide