Other Network Architecture Subjects

Hi,I have tried the ACS 3.1(1). When I use IE5.5 with Windows 2000 prof (setting Traditional Chinese as default language) for remote admin, the NAR input options become gray in color and cannot input settings. Does ACS3.1(1) support Windows 2000 prof...

Please can we present a IGB link line as a RJ45 so that we can put it on a Cat 6509 with a 1000BaseSX Ethernet WS-X6416-GE-MT slot.? Or what should it be presented as for it to be linked into one of this ports.?

Due to some reason, my PRI router need to be configured multiple dialer profiles with multiple dialer pool-member #. The "isdn call interface" command does not succesfully carry out and failed when display by using the show isdn history command. This...

I have a 2610XM router with (1) 10/100. I will have (2) VLANS. Is there a way to configure both of the VLANS on the router so they can both take advantage of my DHCP server located at another site? (If I use a secondary IP address that network can...

Anyone know of any good resources for learning about ATM clouds, etc.?

Hello, i must configure a 2610 with IOS 12.2(8)T that have a WIC 1MTF-G703 to receive incoming calls, but I no have idea.Can anybody help me, please?

Hi all,Cisco 836 comes with an ADSL physical interface and ISDN basic rate interface for backup connection and it is also ready with firewall and IPsec .Can the ISDN interface be configured for normal WAN connections like Dial on Demand?If yes look...

I have a 100baseFX MM sup ws-x5506 w/ 32MB dram and 8MB flash running 4.5(13a). My question is what is the next rev I can go up in upgrading the supervisors code.

Hi,In full mesh IBGP network(please refer diagram below), will 192.168.210.0/24 net-mask updated on BGP routing table? or will it ignor since this network is from same AS? Thank you in advanceDongISP1 ISP2 | | | ...

Can SSL be done with NAT, and if yes, is there any configuration needed for it?Thanks

Hi, I have a Cisco 7206 VXR router with NPE 300 processor. I was trying to replace the existing 16MB PCMCIA card in the I/O controller PCMCIA slot with a new 48MB Flash disk to accomodate a 12.2(T) image but I am unable to format the new Flash di...

We are trying to configure a serial interface in X25. Our X25 subscription specifies that SVC 0 is used. All the X25 CISCO commands to configure the SVC range start with SVC 1, how is possible to configure the cisco in order to us...

Just a very quick question: are RSVP and RTP Cisco proprietary protocols or nit ??Thank you

Does anyone have configs for it can it be done???Regards