09-23-2004 07:01 AM - edited 03-02-2019 06:42 PM
Hello
I would like to know if someone already configured a "controller SONET" and if is possible configure a interface like that on a SDH ring. I didn't found any good documentations on the Cisco web site related.
Thanks
Demetrio
09-23-2004 08:20 AM
09-27-2004 06:20 AM
Hello Mr Smif
Thanks for the documentation, but the big doubt is related of the clear channel configuration, becuase I'll use this interface on a SDH ring and I must change the frame from sonet (default) to sdh and the clock and I'll like to use a single channel (STM1) on this interface, but I didn't found a especific information that show how to associate a virtual ip interface on this "channel (STM1)".
Thanks.
Demetrio
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide