Other Network Architecture Subjects

Hello I would like to know if someone already configured a "controller SONET" and if is possible configure a interface like that on a SDH ring. I didn't found any good documentations on the Cisco web site related.Thanks Demetrio

Hi all,I have CW DF sending email for a router .it is as followsthis email was sent sept15 at 6:22PMInCharge Domain : DFM Active: Router True NY.abc.com PerformanceException - System is experiencing POrt or Interface performacne problems.this email w...

We are having a problem with DFM. We are getting alerts fine, but after a few days the alerts stop coming, and the only way we can get the alerts going again is to restart the Ciscoworks processes. What can we do to fix this problem? Why is this happ...

We have recently installed two cisco4507s with the following IOS: cat4000-I5K91S-M, Version 12.2(20)EW.When we do a MIB walk there doesn't appear to be an ifindex.1, it starts at ifindex.2. This means that one of our management machines fails to dis...

Hello all-I recently picked up a 2610 and a nm-1e1r(1 ethernet, 1 token ring) card on ebay. Well opening the box, I am like a child on my birthday...but putting a console on it and booting it wass like the cake fell on the floor.When I boot the rout...

I know I must be missing something easy here, never had these problems with NAT before...We have a direct connection between us and a customer of ours. They were using some IP addressing that we were using elsewhere, so we decided to NAT the small s...

Hi AllI have a question about using the SPAN on C6500 to analyze the packets on our backbone.I found a document(id:10570) in the TAC, it describe considering the hardware architecture, no performance impact on the switch.But when I asked a Cisco engi...

Hi ,I have three switches connected to each other through fibre . One of the switches which is in client mode needs to bre reloaded with some new IOS . I have been told there will be a network outage for one minute while all the other switches confi...

I have a Catalyst 5500, and on some of the heavily used 100BaseTX ports I have quite a high error rate - sometimes as much as 500 part per million. This happens on quite a few ports, spread over several cards.The "show counters" tells me that these ...

We have a 5509 core switch that is getting constant messages like:2004 Sep 20 12:05:32 central -05:00 %MLS-4-MOVEOVERFLOW:Too many moves, stop MLS for 5 sec(40000000)2004 Sep 20 12:05:37 central -05:00 %MLS-4-RESUMESC:Resume MLS after detecting too m...

Hi,I have a 3 site triangle, with a 2621, an 827 and a SOHO97, all have a link to each other, but when i try and do rip routing - it only works between the 2621 and the 827, the soho97 only seems to take part when it is seeing the RIP traffic via the...

We are currently migrating a large number of devices with unix and when using the deleteDevice.pl I get a failure occured with the following: Probable Cause: A database read error occurred when trying to read the device data for this device. Recommen...

Hi,I would like to get all the MAC addresses of the systems connected to my Cisco 4506.I already tried show mac-address-list and then I selected only the unicast addresses.But the quantity of them varies on time and I got reported only a few of the d...

Hi,What does the Keyword "extendable" in the IP NAT Configuration make or how it works.Example:ip nat outside source static network 10.10.10.0 10.96.0.0 /26 extendableThanksAli